Digital Equipment Corporation |
Spacers |
Flip Chip - Card Spacers |
32 |
BA11-ME |
LSI-11 4x4 Back Plane with H780 Power Supply
Backplane can easily be updated to 22 bits |
1 |
BC05W-10 |
10 ft. BC05W cable |
1 |
BC05W-15 |
15 ft. BC05W cable |
1 |
BC06R-06 |
6 ft. BC06R cable |
1 |
BC11A-02 |
2 ft. UNIBUS cable |
2 |
BC11A-02.5 |
2.5 ft. UNIBUS cable (INMAC) |
2 |
BC11A-03 |
3 ft. UNIBUS cable |
1 |
BC11A-04 |
4 ft. UNIBUS cable |
2 |
BC11A-08 |
8 ft. UNIBUS cable |
1 |
BC11A-10 |
10 ft. UNIBUS cable |
4 |
BC11A-15 |
15 ft. UNIBUS cable |
1 |
G180 |
DEC Pack Read/Write Card for RK05(F) |
3 |
G727A |
UNIBUS Bus Grant Card |
13 |
G7728 |
Power Connector Board for a DD11 Unibus Backplane |
3 |
G938YA |
DEC Pack Head Position Servo Preamp For RK05(F) |
3 |
H-850 |
Flip Chip - Card Extender |
30 |
H780C |
Power Supply with Console Control |
1 |
H3006 |
8 line EIA Serial Port panel |
3 |
LA120 |
LA-120 Dot Matrix Print Heads
New, In Unopened Shipping Containers. |
1 |
M101 |
Flip Chip - Bus Data Interface |
2 |
M111 |
Flip Chip - 16 Inverters |
7 |
M113 |
Flip Chip - Ten 2-Input Nand Gates |
7 |
M115 |
Flip Chip - Eight 3-Input Nand Gates |
1 |
M302 |
Flip Chip - Dual Delay Multivibrator |
4 |
M7258 |
LP-11 Line Printer Interface (Dataproducts interface) |
1 |
M7264-EB |
KD11-F LSI-11/03 processor with 4-Kword MOS RAM |
2 |
M7264-HB |
KD11-F LSI-11/03 processor with 4-Kword MOS RAM |
1 |
M7264-HB |
KD11-F LSI-11/03 processor with
4-Kword MOS RAM and FIS chip |
1 |
M7264-YA |
KD11-F LSI-11/03 processor with 0-Kword MOS RAM |
1 |
M7270 |
KD11-HA LSI-11/2 CPU, 16-bit Caution: uses BC1, BD1, BE1, BF1 for purposes other than BDAL18-21 |
1 |
M7454 |
TU80K-CP TU80 interface (Dilog/Digital) |
1 |
M7485-YA M7486 |
M7485-YA UDA50-A UNIBUS Radial disk interface PR board with blasted ROMs
M7486 UDA52 UNIBUS Controller for SDI disk drives (UDA SI) |
2 |
M7485-YA M7486 |
ROM set for the UDA-50 |
1 |
M7504 |
DEQNA Bulkhead connector and 36 inch cable |
1 |
M7504 |
DEQNA-M Qbus to ethernet adapter, Q22,
obsolete for VMS 5.x and above (use DELQA).
This module is NON Functioning |
2 |
M7680 |
DEC Pack Index and Sector Card For RK05(F) Card |
3 |
M7681 |
Cylindar Address and Difference Card For RK05(F) |
3 |
M7701 |
Control and Interock Card For RK05(F) |
3 |
M7792 |
M7792 DEUNA port module, UNIBUS to ethernet microprocessor.
Not Functioning - Parts Only |
3 |
M7793 |
M7793 DEUNA link module, M7792 to ethernet bus line unit.
Tested - Functioning |
3 |
M7800 |
DL11 UNIBUS Async transmitter & receiver,
110-2400 baud, no clock (Replaces KL11,
which consisted of M780, M105, M782) |
2 |
M7819 |
DZ11-A UNIBUS 8-line double-buffered
async EIA with modem control
(50 to 96-Kbaud, 64-byte silo) |
7 |
M783 |
Flip Chip - Unibus Drivers |
2 |
M785 |
Flip Chip - Unibus Transceivers |
5 |
M7940 |
DLV11 Serial Line Unit (SLU, Async) |
6 |
M7944 |
MSV11-B
4-Kword 16-bit MOS RAM (external refresh) |
4 |
M7946 |
RXV11 RX01 8" floppy disk controller
Operational Status: Unknown |
2 |
M7954 |
IBV11 with GPIB Cable
IEC general purpose interface (IEEE 488/GPIB) |
1 |
M7955 |
MSV11-CD
16-Kword 16-bit MOS RAM with on-board refresh,
18-bit addressing only. |
2 |
M796 |
Flip Chip - Unibus Master Control |
1 |
M8027 |
LPV11 Printer Interface Module (centronics) |
1 |
M8043 |
DLVJ1-M 4-Line Asynchronous Interface
(formerly DLV11-J)
(CS Rev. E or earlier incompatible
with KDF11-A and KDF11-B)
(CS Rev. E or later, ECO M8043-MR002 installed) |
2 |
M8044-DB |
MSV11-DD 32-Kword 16-bit MOS RAM |
2 |
M8049 |
DRV11-J Hi-density parallel line unit (4 lines x 16 bits) |
1 |
M8059-KF |
MSV11-LK 128-Kword MOS RAM, single voltage
This Module is NON Functioning |
1 |
M8067-KF |
MSV11-PK 256-kbyte MOS memory with parity CSR |
2 |
M8186 |
LSI-11/23 CPU 2 Chip
MMU / No FPP |
1 |
M8186 |
LSI-11/23 CPU 3 Chip
MMU / FPP |
1 |
M8186 |
LSI-11/23 CPU 3 Chip
MMU / FPP
NOT WORKING - PARTS ONLY |
1 |
M8192-YB |
KDJ11-AB LSI-11/73 CPU, 8-Kbyte cache,
with FPJ11-AA installed. |
2 |
M8750-CJ |
VAX-11/750 1Mbyte MOS memory assembly |
1 |
M9014 |
UNIBUS to 3 H854s |
1 |
M920 |
Unibus Jumper |
2 |
M9202 |
UNIBUS connector, inverted
(M9192+M9292 assembled 1" apart with 2' cable) |
3 |
M930C |
Unibus Terminator Card |
2 |
M9302 |
A/B Unibus Terminator
11/04 UNIBUS terminator, far end
(Fits in any Standard UNIBUS slot,
terminating all newer UNIBUS machines.) |
1 |
M9313 |
UNIBUS exercisor + terminator (UET) |
1 |
M9400-YA |
REV11-A 120-ohm terminators with refresh & floppy boot |
3 |
M9400-YD |
REV11-D Headers alone, no terminators,
Cable connector (18-bit bus only). |
1 |
M9401 |
Mirror-image connector used at other end of cable
to M9400 to join 2 backplanes. 18-bit bus only,
No terminators. |
2 |
RK05F |
Head Assembly |
1 |
RK05 |
8V To 20V Regulator ATC 20-14-77 |
6 |
RK05 |
8V To 20V Regulator ATC 20-25-77 |
3 |
RK05 |
Absolute Air Filter |
1 |
RK05 |
Blower Fan |
3 |
RK05 |
RK05 Cartridge Springs |
4 |
RK05 |
RK05 Cartridge Door Lifter |
2 |
VTxxx |
VT KeyPad Overlay |
3 |
--- |
Electrostatic Shield Hex Wide |
5 |